Das V8 Coupe Quattro

[oprahhwinfreyy]

Software your using? For the 3d models

[stinkinrich]

Just noticed you're over on motorgeek.com. Could you point me out to any projects that have fitted a 4cyl 1.8 20vT into a B4? Trying to look more into it..

[dspl1236]

bought a 20th gti to part out to hep fund this project move quicker

[Edward]

amazing work man- just caught up on everything!

[dspl1236]

[dspl1236]

Wonder how hard this would be to install on my B5

i do not thin k it would be too bad to do. i have heard the audi to toyota high pressure line is the hardest part. i am just going to go a a hydro line shop when i am ready

[NeedingAnAudi]

waiting on my buddy to get his new cnc setup.

'91 MR2 Electric P/S Acquired

Wonder how hard this would be to install on my B5

[dspl1236]

[dspl1236]

back to fabricating...need to cut out a section of the rear floor. while i was at pull a part wandering around looking at radiator and electric fan setups and warming my hands...saw some great ideas...then got back to the mr2 i was working on and finally made up my mind on a rear mounted radiator. Toyota did a nice job on that mr2 in its mid engine design. neat little car...just will never own one.

[dspl1236]

waiting on my buddy to get his new cnc setup.

'91 MR2 Electric P/S Acquired

[dspl1236]

would be sweet....

this is the fixed version v4.2. intake flange faces and block width are now correct. still have not made a shorter/easier to machine v5 flange yet....

[dspl1236]

nowhere to put velocity stacks!



to the garage!

[dspl1236]

set of 8

too close. v5 is already in the works

[sumpcracker]

Set of 4 on open trumpets.

[NeedingAnAudi]

less rendering more manufacturing.