If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
thing my mate who shares my lock up has a mk3 seat loom from his old valver going spair .. check out our fb page if you click UnderStated on my sig and drop us a message
Ah cool, I already liked that page. Just sent a message. Thanks
thing my mate who shares my lock up has a mk3 seat loom from his old valver going spair .. check out our fb page if you click UnderStated on my sig and drop us a message
I got the switch from someone on ebay who is also on ed38 he gets quite a lot of little rare bits and switches, the mk3 loom plugs into it and you can wire it in with a few mods I haven't properly looked into it yet but I cant see it being a hard job. My plan was get some mk3 heated seats as them come with the relays on the bottom and take the heat pads out and fit them into mk2 seat pref recaro when I eventually get some sorted.
Also an idea on your amp placement , I had mine mounted behind my rear door card so in the quarter make a few brackets up and you laughing
Thanks mate I need it just started a decent full time job after the past 5 years at college/uni so I will be able to get cracking with money coming in. I have a build thread on a local forum but I haven't updated for a long time , im gona put something together when I make some decent progress
I did think about putting the amp behind the rear doorcard but thought it will be a bit of a pain to get to to adjust settings. It's ok under the middle of the rear seat now.
I was wondering if the mk2 switch is the same plug as the mk3 one. Cool. Might have to buy a mk3 setup then. And then try and find a good switch.
Thanks. Im really wanting some heated seats. Good luck with yours. You got a thread?
.
I got the switch from someone on ebay who is also on ed38 he gets quite a lot of little rare bits and switches, the mk3 loom plugs into it and you can wire it in with a few mods I haven't properly looked into it yet but I cant see it being a hard job. My plan was get some mk3 heated seats as them come with the relays on the bottom and take the heat pads out and fit them into mk2 seat pref recaro when I eventually get some sorted.
Also an idea on your amp placement , I had mine mounted behind my rear door card so in the quarter make a few brackets up and you laughing
Thanks mate I need it just started a decent full time job after the past 5 years at college/uni so I will be able to get cracking with money coming in. I have a build thread on a local forum but I haven't updated for a long time , im gona put something together when I make some decent progress
looks fantastic my man. I don't really post here very often but i just had to commemorate you on the attention to detail. top notch stuff. its all in the details.
looks fantastic my man. i dont really post here very often but i just had to commemorate you on the attention to detail. top notch stuff. its all in the details.
Leave a comment: