Camaro SS build

[CrackerTeg]

Haha what is that from ?

No idea. I thought it was the perfect gif for this though. lol

[LCG]

I liked it better without the kit but still looks very nice..

Saw your posts over ls1tech...

[Skraight.]

Haha what is that from ?

Good god that looks so low now, making mine look like poop

No you're car is pretty dope. If I could put my air ride/motor in your car I would

Looks a lot better than I expected.

Thanks the camaro forums are ****** it so far

[RubbderDucky]

Looks a lot better than I expected.

[94_SlammedZ28]

Good god that looks so low now, making mine look like poop

[CrackerTeg]

[Skraight.]

Lip kit installed





Will also be changing up the car color soon, not sure if I will be going root beer metallic or a blue with green pearl or something crazy.

[Skraight.]

My new shift knob and short stick for my hurst shifter came in. Don't mind my pale white arms/legs

Also ordered a porter cable, with paint correction stuff and glaze/sealant/wax all that fancy stuff.

Trying to get into car detailing on the side.

[Skraight.]

I heated up and beat the inner lip so its flat with the exterior. Even when the bumpstop is fully compressed against the axle it doesn't touch or hit anything anymore.

[f50nut]

Just went through the whole thread. Props for figuring out how to lower this thing. I have a 2000 SS, red, same as yours. It's on Konis and Strano springs and the gap is just ridiculous.

Just a question - how do you go flush without the wheel colliding with the rear quarter? Since these have panhard rod setup on the axle pivots up and to the side. I know because I've cut my left rear tire over heavy bumps even though it's evenly adjusted left to right when sitting still.

[94_SlammedZ28]

I Cant wait to see how those side skirts fit, ive been wanting them for a while but idk how theyd look, and i feel like theyd get ripped off within like 10 minutes. lol

[Skraight.]

Thanks, still not nearly where I want it but slowly coming around.

Just got done backyard painting the lip kit. Came out pretty good, only have 1 run I need to take care of. Going to let the clear harden for a day or two then hit it with wet 1500 and 2000 grit.

[LCG]

looks awesome.. If I saw that picture a year ago I would not have sold my f-body.. nahhh

[Skraight.]

The lip doesnt have any mounting tabs for the inside of the bumper? Mine did, i just screwed it in to the bottom, 3m tape would just rip off.
And the bride was a friends, lol i wish it were mine, but i did pick up the recaro))

It does yeah, but I don't like how the front slips over the bottom of the bumper. It's almost like a cover more than a lip.I'm trying to figure out if I can get it to sit flush with the bumper and not have to overlap the bumper.

[94_SlammedZ28]

The lip doesnt have any mounting tabs for the inside of the bumper? Mine did, i just screwed it in to the bottom, 3m tape would just rip off.
And the bride was a friends, lol i wish it were mine, but i did pick up the recaro))