Twerk-cedes Benz

[aLaFleur]

I already said this and you shut me down.

Admit that you were wrong and that you secretly love me

Yea... That's still not happening.

[floatingdino]

Turn the pipe upwards. cut hole in hood. connect flame thrower. shoot flames from hood!!!

I already said this and you shut me down.

Admit that you were wrong and that you secretly love me

[aLaFleur]

Neeeds bigger exhaust!! Use that diesel pipe on the side of the shop

I already cut some of that pipe up last night too.

Turn the pipe upwards. cut hole in hood. connect flame thrower. shoot flames from hood!!!

Oh, the flame thrower will be back. Don't you worry.

[mekken]

Turn the pipe upwards. cut hole in hood. connect flame thrower. shoot flames from hood!!!

[244Brick]

Neeeds bigger exhaust!! Use that diesel pipe on the side of the shop

[Yezzz]

Something tels me that the exhaust will be near the front wheel, not sure if true but I am so glad that there is progress. This thing is so epic xD

[Thom]

I can tell it will be obnoxious and I'll love it. FK YEA!





Seriously I will like it.

[aLaFleur]

Started the exhaust last night. This is just a teaser of a mock up of only one bend until I finish building it all. Go ahead and make some assumptions if you'd like. I will say It's going to be loud as hell.

[aLaFleur]

For real? Time to break out a few quarts of ATF and dump them in the cylinders to see if they free up.

Not for real

that seriously sucks ashton, especially after all the progress that was made

Actually, I made a shit ton more progress last night. Tracked down an oil filter that was short enough to fit, got the distrib in, plugs and wires, ordered a small starter and carb rebuild kit, blah blah Going to start wiring it up this week I hope.

Did you just cut it down or did you modify suspension also because if I shorten mine I may be able to use my trans

I cut it down, but I haven't addressed the change in steering geometry yet. However it's going to be as simple as an alignment as far as I can tell. I'll get you the exact measurements of what I did. Hopefully it's enough to clear yours too.

[CB7_luver]

Shortened this stupid thing by about 4 inches for bellhousing and starter clearance.

Did you just cut it down or did you modify suspension also because if I shorten mine I may be able to use my trans

[P78]

that seriously sucks ashton, especially after all the progress that was made

[Earl]

For real? Time to break out a few quarts of ATF and dump them in the cylinders to see if they free up.

[aLaFleur]

Happy April Fools day to you too=)

I wish that was true... I tried to roll it over with a 1/2" ratchet last night to get the distributor in and in time and it won't budge.

[Earl]

Happy April Fools day to you too=)

[aLaFleur]

Turns out this motor is seized... No way in hell I can fund another one by sowo. I swear this car... ugh