The Negative Camber Appreciation Thread.

[Tuck&Poke]

Whore this pic around :p

2.8 front, 0.8 rear, stupid rear beam


btw, i think i've seen this username on here, so if you see this, thanks for the pic, one of my faves from SC2

[DudeDude]

ittle tiny bit

[Rally]

Rake is measured by rockers, not gap

Thankfully

[Jersh]

new wheels?

[M.Burroughs]

Rake is measured by rockers, not gap

[Kielan]

Tis reverse rake, spin the rears up a bit, or take a collar out up front.

[armanduhx3]

Reverse Rake:




Most cars have rake... front rake..where the front is lower then the rear.
But since my front coilovers are bottomed out, and my rear is lower then the front, its known as reverse rake. I think...

[skrapez]

bonnet is an ugly thing a woman wears on her head...

[Kielan]

Bonnet.

[andybob]

Really? I could have sworn his bonnet was on backwards...

Its a hood.
:

[EtownC]

Same.

Serious reverse rake:



To settle this debate, I challenge reverse rake boy to get a tape measure, measure at the front part of the pinchweld, record measurement, then measure at the rear, record measurement, and report back to us. Make sure the car is on a level surface though.

thanks capita, no this is all brought on from someone in the comments page on the front page. i get a kick out of it. his comment was "Are the homemade coilovers an excuse for reverse stance?"

None of that comment makes sense to me. so i made a signature, and from now on im reverse rake boi

cheers

edit: and yes everytime i put suspension in i measure each fender to wheel gap to make it square.

[Oxer]

You have too much toe out, nothing an alignment can't fix.

Really? I could have sworn his bonnet was on backwards...

[andybob]

I know.. I can't figure out what the hell everyone is talking about with that being reversed rake.. maybe i'm just looking at it from the wrong angles, but it looks pretty tits to me.

Same.

Serious reverse rake:



To settle this debate, I challenge reverse rake boy to get a tape measure, measure at the front part of the pinchweld, record measurement, then measure at the rear, record measurement, and report back to us. Make sure the car is on a level surface though.

[stale30]

[VrDubssat]

its not much...