Cougar House Garage Project Sacrilege Ford Super Duty

[CougarHouseGarage]

Heres the pic's of the trucks first show







What do you guys think?

[CougarHouseGarage]

Thanks for the link! Looks like they have a lot of good stuff. What show are you guys going to?

We went to the 4wd swap meet show in puyallup Wa on march 6

[Fleetlin49]

Thanks for the link! Looks like they have a lot of good stuff. What show are you guys going to?

[CougarHouseGarage]

Loading up for the first car show the trucks going to

[CougarHouseGarage]

I got the custom made radiator and intercooler back from Doug at Up Garage in Tacoma,Wa one off

[CougarHouseGarage]

Where did you get the expandable mesh loom? It looks like you used a bunch of it. It makes your wiring look so clean!

loving this,

that expandable mesh looks great! so much better than normal shit suff

Thanks guys I think so to, I got if from delcity.com

[Lukey]

loving this,

that expandable mesh looks great! so much better than normal shit suff

[Fleetlin49]

Where did you get the expandable mesh loom? It looks like you used a bunch of it. It makes your wiring look so clean!

[CougarHouseGarage]

Heres the pics of the new glass that went in last week,the rear window is a solid with privacy tint

[CougarHouseGarage]

Love your updates and the quality of your workmanship

Thanks man

[The Simps]

Love your updates and the quality of your workmanship

[CougarHouseGarage]

Started building the valve harness

I love expandable mesh loom and shrink tube



I arched the grounds together and ran through the harness to near the Accuair ECU

Controller harness, headlight wire and ignition wire need to be ran into the cab

[CougarHouseGarage]

I installed the Destroked 60-1 tone wheel for the tech

2011-2015 B-piller panels


The ford adaptor brackets for the 2011-2015 B-pillers panels

Lower B-piller panels

Time to bolt down this tool box

Stainless steel 3/8 button head bolts and nylocks

I got some AN fittings for the transmission cooler lines and finally some vice jaws

[CougarHouseGarage]

Got the tool box back from my friend Eric with the TIG welder he mad mounts for the tanks and a aluminum battery box

Now its time to setup the Accuair electrics I like these MIDI fuses much easier to work with then maxi fuses

To compressor relay

Soldered and shrink tubed

Accuair ECU 12volt

The white wire is my ground like toyota uses

[CougarHouseGarage]

3/4 Borgeson lathed out to fit on the ford steering shaft

Front Accuair E-Level sensors installed that was tuff I tell you