Just another E30 build.... (a.k.a. The Bronzit B*tch)

[K-Line]

Nice updates. Shit about the bead, but there is always one...

ALWAYS, but itll get fixed.

I gotta stop drooling over e30 builds and get one for my self...

Just do it!

[K-Line]

ITS OFF TO FINALLY HAVE THE RUST REPAIRED!

HERES AN OLD PIC

[mikey G]

Awesome. What were the worst spots? The usual shit...behind the arches, floor pans ect?

[K-Line]

Awesome. What were the worst spots? The usual shit...behind the arches, floor pans ect?

The floors where fixed at the beginning of the summer so they're good now, so the spots being fixed now are right behind the rear wheels. The corners where the wheelwell comes down are gone, plus theres like two quarter sized hole in the wheelwell itself. Hopefully it'll be done by next weekend.

[adjustedposture]

Looking fantastic Keep up the great work!

[K-Line]

Looking fantastic Keep up the great work!

thanks will do!

[DER E30]

Looks killer! How much lower will aired out be?

[K-Line]

Looks killer! How much lower will aired out be?

Probably about 3 inches lower than the lowest i could go on coils, hoping to be able to set the front valance on the ground, and fender to lip. would really love to tuck the rear...

[DER E30]

That looks dang good right there! Can't wait to see it dumped!

[K-Line]

Forgot to post this, finished my first full top end rebuild on our vert; need to do another valve adjustment but it runs nicely and the idle is on point!

325ic First Start from GREGKLINE on Vimeo.

[mikey G]

You age fast man! You went from looking 15 to looking 55! . On a serious note, I could fall asleep to the beautiful tick of an m20. Adjust those valves to 0,30 and tick away !!!

[K-Line]

You age fast man! You went from looking 15 to looking 55! . On a serious note, I could fall asleep to the beautiful tick of an m20. Adjust those valves to 0,30 and tick away !!!

I adjusted to .25mm/.010in like it said in the haynes/bentley manual, i cant remember which one. Do you recommend going up to .30mm? I think i might have just missed a valve when I did it the first time.

[K-Line]

Got this picture from my dad today! The rust repair is done so the car is ready to be torn apart when i get home on friday morning with my homie Dave.



Also picked up an IS front valance from the pick and pull for $12, sold it to Ian (eethirty) for some powdercoating and cash on top.



Going back tomorrow to get more stuff from the car like an IS spoiler and the interior just because its cheap.

[mikey G]

Ehh no you will be just fine where youre at . I just guessed ,30 because the valves were very loud. But I was close enough .

[eethirty]

yea buddddyyyy