my 1994 "Econo classic" Toyota Tercel

[74low145]

Haha so rad, need to see more!

[AstroVannin]

Pics will follow.

Tires now installed on wheels, got a new unmolested engine harness, and picked up a set of NOS 75 corolla bolt on fiberglass flares I might try.

Valve cover is powdercoated now too.

[lowdown65]

and this is the valvecover and im the powdercoater

[Mk4WiLk01]

cant wait to see this thing finished!! keep up the good work

[xAaron]

Man this thing is awesome!

[lowdown65]

build is going slow and steady

we have huge ideas planned for the car , just need the time too do them ,

[TheTynosaur]

In to see how this turns out

Sent from my HTC 3D using Tapatalk 2

[keenan]

whats the lowest point on these cars? like what will you hit first? exhaust and then what?

[Ben_S]

Haha so rad, need to see more!

+1

[j3wman]

oooh damn this is a dope build too

[AstroVannin]

Oil pan and control arms are about the same height, the floor pan itself isn't far off that.

So basically, everything hits at once lol.

Progress was made on the weekend, pics to follow.

[floatingdino]

I fully support this build.

[AstroVannin]

Well, front suspension and steering is done (maybe some slight tweaking). Heim joint tie rods worked brilliantly, axle angle is a bit aggressive though. Stevie wonder was available to lend a hand with the fender rolling, and all thing being equal it came out ok.

Got the new valve cover sitting on there for the time being ... I would say it completely changes the look of the bay. Makes the rest of it look pretty weak lol.

Had to cut up the strut towers to get enough camber in the front. I’m sure there’s lots of nicer ways to do this, but it’s unlikely that this will be the final configuration for the towers since they will have to be remade to accommodate strut bags.

[SheaMoose]

Looks bad ass.

But I don't know about your camber solution.

[kaidotech]

Sub'd. Looks epic man. Ill reserve judgment about the pillowballs until theyre finished.