Hammer-Time:. Can't Stance This

[indy510]

[sixty-nine-dime]

love how clea it is! it used to be lowwer.. what happened?
and ya its a KA

[HouseOf1817]

mhm, shes a dirty gurl

[jcruz]

id love to see stanced

[BLKonBLK98]

this thread makes no sense to me.

[HouseOf1817]

haha, i didn't read it. but either way this car is going to be stanced wether or not you can comprehend.
cause if it doesn't happen i will run to OP's HT and tramatize him

[Oxer]

It is rediculously clean, for the most part, but this thread makes no sence to me either.

[indy510]

.

It is rediculously clean, for the most part, but this thread makes no sence to me either.

All of the pictures so far are after I raised it back up with the stock suspension

I "borrowed" the 510's front suspension for a few weeks last year......... and those pics are on the next page

[indy510]

.

The 510 sits alot lower:

[indy510]

[Mexican]

[indy510]

.

Chapter 2:


Here's a video of the wagon driving with the OBX header,,, and a temporary Glasspack bolted onto the header:

[ame="http://www.youtube.com/watch?v=NIjYEWeWq6c"]YouTube - KA710 glasspack[/ame]


and a burnout video.... (before the header):

[ame="http://www.youtube.com/watch?v=elvhx4LeAlA"]YouTube - RAT710KA[/ame]

[indy510]

.

January 2010:


I built this front suspension for my 510 ..... ... ..and it is already back on the 510 so it can roll


But the wagon was begging for moar low .......




So the 510 struts were shortened and re-threaded..... coilover perches welded on ...... #225 springs.... DPR Camber plates


























Base coat:







Clear Coat:

[indy510]

.

So while the 510 was getting under coated........ .. I tried on the shortened 510 struts and Willwood brakes:




From left to right: 12.1" rotor on shortened 510 struts......stock 510 rotor........stock 710 strut....stock 280zx strut


















1 inch RCA (Roll Center Adjusters): . . . . . . . . to help correct the suspension geometry of the LCAs








adjustable 510 T/C rods next to stock 710 rods ........... seems like they wil work:

[indy510]

.

Is this low enough???






: ......... same wheel gap as before........... but the front wheels are off the ground in the pic above ........