Stanced Trucks?

[Reubencanyon]

U daily it on slicks?

[bmw325e30]

working on this right now, just need dream beams shorter coils and an axle flip:





the truck is my daily and i have about $1200 into it including the truck and the wheels/tires:



-Garrett

[stihlayota]

im running western chasis leafs n they are very stiff, i haul way more than the truck should all the time with no problems or bouncing

[Belvader]

that ranger is insanely low! lets see some wheels on there this spring.

thanks playa and im tryin my dude, tryin

Thanks Belvader. It's a little lower in the front since I put some thinner stops on it. Back springs are belltechs. Not real impressed by them. A little soft for my tastes. I could probably block them a little more and get it lower but I just use it when I need a truck, lately.

no prob dude, its a clean ride just needs smaller wider wheels and moarrr low

[stihlayota]

^yup unless the aftermarket wheels mentions the center bore size. when i put chevy wheels on my hardbody i had them bored for like 15 a wheel

[aeion]

Gotta quick question for the truck guys, will chevy 6x5.5 steel wheels fit on a 96 nissan hardbody without any modification or will I need to bore the center or something?

You'll have to get the centers bored out to 4".

[Low N Slow 777]

Gotta quick question for the truck guys, will chevy 6x5.5 steel wheels fit on a 96 nissan hardbody without any modification or will I need to bore the center or something?

[heeter_33]

Every time I look at this thread I want meshies even more.

[stihlayota]

ill check them out project, thanks!

thanks for the pics red, looks about the same amount of travel as me. my stops i cut in half for that little extra lol. once the weather starts to clear up ill take some pics n try to figure out what my options are.

[RedLiqourice]

that ranger is insanely low! lets see some wheels on there this spring.

hmm looks like the same arms as me, do you know the brand? i was thinking of just picking up some stock lowers to run spindles and springs. how much travel do u have? im not looking for or expecting a plush ride but sitting on bumps gets old fast. the rear rides very good, i cut the bump brackets off and rarely bottom out.ill will throw 3inch blocks in there. maybe 4 after the notch is put in. the strange thing is the winter wheels r growing on me too lol. i would really like to throw a set of diamond racing 16x10's on there and have little to no gap.

red-do you u think you could snap some pics of ur control arm clearance to the stops? im really liking how ur truck sits.

winter is taking too long!

without flares on 225/55/16

[projecthoarder]

Did you try Bart Racing wheels?

[stihlayota]

i looked all over last night and nobody has a 16x10 w/5x4.75..... also while i was googling i read quite a bit of negative stuff about diamond racing wheels. i looked at basset wheels too but they do not make a 16

[TrailerTrash]

ive done the same thing with 2 sets of fully chrome wheels. i used spray paint both times and it held up very well but im going to use plastidip the next color change.

[stihlayota]

lol hmmmm

[dubmr2]

you can get some of the jegs/summit wheels in full chrome and then paint the centers. thats what I did

15x8-19 or something crager i think



its like 12$ more than the painted ones i think lol