brag about your hp!

[2jzcress]

91 toyota cressida ..2jz swapped with a precision 6265 billet single turbo setup & a 5 speed conversion w/ r154 trans & excedy twin plate clutch ... low boost it put down 430ish @ the wheels and about 418 toque

[conski]

91 toyota cressida ..2jz swapped with a precision 6265 billet single turbo setup & a 5 speed conversion w/ r154 trans & excedy twin plate clutch ... low boost it put down 430ish @ the wheels and about 418 toque

I'm not a big fan of jap cars but you sir have got one badd mothafuckin ride. I like how clean it is under the hood without really trying to be (i.e. tucked wire shit). Good job.

[2jzcress]

ha thx bro ... i built it to look like it belongs there .. also w/cold a/c good luck with that C.I.S. HAHAHAHAHA

[andybob]

91 toyota cressida ..2jz swapped with a precision 6265 billet single turbo setup & a 5 speed conversion w/ r154 trans & excedy twin plate clutch ... low boost it put down 430ish @ the wheels and about 418 toque

your fucking winning.

Well done sir.

[conski]

ha thx bro ... i built it to look like it belongs there .. also w/cold a/c good luck with that C.I.S. HAHAHAHAHA

hahah a/c doesn't work, which I don't really care about except on those florida summer days when the temperature with heat index is 110 degrees. But I must say, the CIS isn't that bad if you understand it and are willing to be patient/ work with it. If you have a strict EFI mindset then you are screwed when it comes to this system lol

[2jzcress]

yaaahhh i werk on merc.s at at small independent shop .... i know all about cis .. unfortunetly lol

[conski]

yaaahhh i werk on merc.s at at small independent shop .... i know all about cis .. unfortunetly lol

Oh word, well if I ever get stumped on the system then you better believe I'm coming to you with questions! lol

[who says hella]

I want a DA bad.

Can't wait till I'm boosted. .

I can't wait till I get a vtec head. I don't know if I should go with the GSR head or b16a1 head

[StraightDeezin]

N/A s54 on the e46 m3. I've never dyno'd but factory output is 333hp. My plans is to stuff an s85 in there.

an s85 in an m3 would be insaneee

[320icar]

1988 bmw 535iS.

stock m30. 185hp, 215lb/ft.

all its got is a hot air intake (just a k&n) and the maintinance mod. 285,000km on the motor and still rockin' 180psi of compression in every cylinder! good ol' bmw M30 motor

[Kerelm]

rb25det

fmic, pod, turbo back zorst.

278.7 rwhp @ 10 psi or was it 11?

[bev0]

Vw beetle...36hp from factory give or take a few years...id like to think im still in the high 20's lol..same for my karmann

[flemcadiddlehopper]

The Northstar going into my E28 , bone stock withstock ecu and exhaust (while in the Cadi) was 300HP and 300 ft/lbs. With headers,electric waterpump,stand alone ECU, and perhaps down the road a supercharger....well , time will tell.

Gordo.

[T.Reed]

I'm not a big fan of jap cars but you sir have got one badd mothafuckin ride. I like how clean it is under the hood without really trying to be (i.e. tucked wire shit). Good job.

You should hear it Launch control out of a parking lot.

91 toyota cressida ..2jz swapped with a precision 6265 billet single turbo setup & a 5 speed conversion w/ r154 trans & excedy twin plate clutch ... low boost it put down 430ish @ the wheels and about 418 toque

DANNNNNNNNNNNNNNNNNNNYYYYYYYYYYYYYYYYYYYYYYYYYYYYY YYYYYYYYYYYYYYYYYY!

[subeone]

280rwhp, 270 lb/ft