Re-drill questions

[KMK454]

Wheel newbie here. Is it possible to drill and fill open face wheels and not have it ruin the look?

Example 1:

BBS LM in 5x114.3 to 5x120.65.

Example 2:

AC Schnitzer Type 1 three piece re drilled from 5x120 to 5x120.65. The face of this wheel doesn't look like it'd do a re-drill, but 120 to 120.65 is very small.

I understand that in example 2, wobble lugs might work. However, I'd still need spacers, and I've read wobbles + spacers is a bad idea. Also, I've seen people run 5x120s on 5x120.65 and vice versa. My preference is to do it right, though.

Thanks!

[devildriver.ab]

any reputable wheel shop should be able to do that by drilling out the holes and inserting a sleeve that will not be noticeable after lug nuts are on the wheels

[zoo]

Redrilling 120mm PCD to 120.65mm PCD is pointless. as long as the hub is the correct size or a hub ring is used, you will experience no vibration.
114.3 to 120.65 will be noticeable up close(to those who know about redrilling), but I would not say that it would ruin the way the wheel looks.

[konstbug]

what about wobble bolts? 120 to 120.65 is possible

[zoo]

Again, no need for wobble bolts for that.