Will they fit?

[joshuawilliams_]

Im a good few thousand miles from you dude

[StatusRacing]

I dont use those sites but how did you measure the poke from the fender without any other measurements? That would be the poke the new wheel would have to his old wheels, without calculating the adapters.

OP, assuming your adapters are a standard size (20mm), 40mm of poke outside of your current wheels before camber is where you will be. The rear wheels look maybe 10mm sunk to me (tough to tell) but either way you shouldn't have a problem pulling them in with a few degrees of camber.

I should have worded my previous post(s) differently. I didn't mean to imply that I had calculated how much poke he would have.

[Ollie]

I should have worded my previous post(s) differently. I didn't mean to imply that I had calculated how much poke he would have.

Oh alright Im sure that was a bit confusing for him since you defined "poke" and then said he would have 20mm of "poke".