Sparking roller

[P78]

moar pics are needz

[too-low-for-costco]

I do have a skid plate and the lowest point on my car is the cross member/Auto trans pan :/ both have a 1/4" steel plate on them. My car is static and I drive it that low on the daily. Scary tho, I've busted the pan three times in the past 5 months, finally welded it up.

Projek I lost the other pics on my lap top ill have to get them from my buddy again. soorrrryyy :/

[projektzwo]

I do have a skid plate and the lowest point on my car is the cross member/Auto trans pan :/ both have a 1/4" steel plate on them. My car is static and I drive it that low on the daily. Scary tho, I've busted the pan three times in the past 5 months, finally welded it up.

Projek I lost the other pics on my lap top ill have to get them from my buddy again. soorrrryyy :/

grrrrr....it's okay, it's okay don't worry...

[runningpanda]

I don't think you're low enough.

[VrDubssat]

1.8t or v6? damn it is nearly impossible to break pans on the b5.5's unless you are off roading. Normally you hit the sway bar or lower control arms before the pan.

[too-low-for-costco]

1.8t or v6? damn it is nearly impossible to break pans on the b5.5's unless you are off roading. Normally you hit the sway bar or lower control arms before the pan.

Its a V6 but the auto trans pan hangs lower than my cross member and my sway bar super lame!