Announcement
Collapse
No announcement yet.
JZZ30 Form and Function Come Together
Collapse
X
-
Pulled apart the tails, measured Perf board and cut it to size. Each light holds 92 LED's total and I will post more photos of my process later.
Leave a comment:
-
Those tails are incredible. How did you do them??? I wanna do something similar on mine but maybe with a star or something
Leave a comment:
-
Lexus is being sold this week as I bought another Merc, anyways here a pic of the tailights I just finished for it

Leave a comment:
-
PHOTO DUMP cause this thread is boring

Love the way these wheels make the car look.



Not much is happening as of now but I'm hoping to GTE swap this thing very soon.
Leave a comment:
-
You could have a machine shop mill the entire lip off down to the flange. Then you could get new lips.
Leave a comment:
-
Found out they are the one piece. Little disappointing but it's not the end of the world seeing as I got them for $600 with tires. I am going to run some spacers for now and move along with my manual swap hopefully. They do look great on the car imo but I wish I had the ability to re-lip them if needed.Originally posted by Okoye View PostYou sure these are the three piece versions? I had the one piece version on my Volvo a couple years ago.Last edited by 190Evan; 06-29-2017, 11:32 AM.
Leave a comment:
-
You sure these are the three piece versions? I had the one piece version on my Volvo a couple years ago.
Leave a comment:
-
FRP, So basically fiberglass reinforced plastic. Annoying to repair but stronger than just fiberglass which is nice because I smash it up on a daily basis. I'll post a close up of the damage, it's not bad at all considering I ran over an F350 full size rear tire that blew up on the freeway.
Leave a comment:
-
Leave a comment:

Leave a comment: