BMW E36, Wilma project

[IGOR989]

Hey guys, Im sorry I didn't update at all... but I forgot I also have a thread on S|W.

But now...you're getting on hell of an update.

Enjoy.

Bought these RH wheels 10J ET 17 in the back and 9J ET-8 in the front



Rolled the fenders up... latter to be cut... you will get to see why.



I got these and these





Cleaned steering rack, with new outer and inner tie rods (later tie rods are gonna be mod'ed)



Freshened up front hubs

[IGOR989]

I had to prime the engine bay... it stared to get rusty.



Rear subframe was painted with polyurethane paint. New bushes were installed, with adjustable D2 racing rear camber arms.







Front end assembly (later my friend needed new wishbones so I sold them to him... and becouse I was without wishbones... I got idea to buy E46 front wishbones... and... I did... aaaand it's ridiculous )



Excentric bushes (sold them with wishbones - have to order new pair)





I can't say anything... that's a nice setup... but not for me

[IGOR989]

More of the wire wheel action.





I also bought M54 B30 bottom end engine block (needed the rotary assembly)





M54 parts



M54 vs. M50 pistons and rods (M54 piston is 5mm lower)



Swaped the parts into M50 engine block (do you notice the 2.1mm below deck position?)





AND THAT'S PHOTOSHOP VERSION OF THE FINAL COLOR COMBO

[IGOR989]

New head gasket, all kind of seals (not all of them on this picture), bearings, etc.



Hydraulic E-brake



I also bought this bad boy... I call it "bam bam" (turbo setup comes after the summer). It's Innovative turbo system turbocharger capable of 650+ HP. It's actually hybrid turbo... with ceramic ball bearing housing (oil and water cooled)





New crankshaft seals



Cleaned but not polished yet



Polyurethane paint again





Pistons and rods were cleaned in ultrasound bath.

[IGOR989]

One mass flywheel was lightened from 10.5kg to 9.3kg. It's not much but it's gonna rev fast, thrust me.





New fuel filter





And that's the reason why I pulled the fenders and why I'll cut them.



It's gonna be less camber in the rear and 20mm spacer I think (I should have one pair of H&R spacers somewhere in the garage).



Bought S50 ITB intake system (much to be moded next week to fit them on M50)





New seals for the intake parts (for the injectors I have to buy them next week)



Took everything apart to clean it and to adjust the idle of the throttles.

[IGOR989]

I gapped the piston rings (all 0.35mm)





Engine block was milled/decked by 2.5mm (Compression ratio should me now 12.x:1). Piston is now 0.4mm above deck.









Got this last week... AFPR - adjustable fuel pressure regulator



I also got this last weekend - heavy duty, kevlar ball bearing housing caster/camber plates















And... that's why (E46 wishbones setup)

[indigais]

nice work so far

[IGOR989]

Thanks.

Soon it`s gonna be on the road. I mean I have to put the engine together... Im waiting for the ITB adapter plate that we are making to be finished and for the exhaust manifold I ordered. Im also waiting for the front lower wishbone bush that I ordered.

[IGOR989]

ITB adapter plates I made... just have to weld in the middle pipes and then the engine is ready to go in... again.





Ported intake





















Budget bucket seats and harnesses, while Im buying Recaro Pole Position



Schmiedmann exhaust headers (for the NA setup, to try the stroker setup)




SOON MY BABY, SOON!!!