If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
engine cradle built. huge thanks to my buddy Brandon for bustin ass and finishing the cradle to get it ready for paint. oil pan sits above the suspension bar so im super stoked about that
yes. not sure what set up im doing but it will be either in the wing or a pair of duals. im just going to get it running NA to start with and build a motor for boost on the side.
If you're ordering custom adapters, call 775.530.2483 to make sure you are getting exactly what you want. Thanks
ok so complete with the bedliner. ran the coolant hoses from front to back. by far the most complex area of this build is the coolant system. i wont go into to much detail, just laugh when the next guy tries this swap and asks...wtf did you do?" haha. also got some banjo ends with hose to loop the rack to make it manual. im still going to run a push pull reservoir to keep the rack full of fluid.
If you're ordering custom adapters, call 775.530.2483 to make sure you are getting exactly what you want. Thanks
found and ordered 1.25" aluminum mandrel bends to make the hard lines for the cooling system. also grabbed a 4" aluminum square stock and making a home brew intake manifold.
If you're ordering custom adapters, call 775.530.2483 to make sure you are getting exactly what you want. Thanks
Comment