If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
When I think about all the stuff I've had to make for this stupid car it makes my head hurt.
Maybe its just me then, cause I love the work that's been done. It really makes it your own when you have this much time into a car. And the fact that it's a cavalier just makes it all the better because it throws people off so bad lol I love them though so it's just amazing to me.
o my, when i started reading this post i was like fucking Cavalier what can he do with that, now im in love lol your doing some sick jobe man LOVE IT!!!!!!
Maybe its just me then, cause I love the work that's been done. It really makes it your own when you have this much time into a car. And the fact that it's a cavalier just makes it all the better because it throws people off so bad lol I love them though so it's just amazing to me.
o my, when i started reading this post i was like fucking Cavalier what can he do with that, now im in love lol your doing some sick jobe man LOVE IT!!!!!!
and where are you in ontario?
Thank you! I'm a little over an hour west of Toronto.
You can always change the way you drive to deal with roads.
Pretty sure you're a scammer. So, politely, cram your spam up your ass.
So, slacking fellas! Sorry. Few little updates.
Ordered new lower rad mounts. Cheapest thing I've bought for the car in a long time. A whopping $14.00.
Finished my brake and gas pedal assembly bracket. I learned that welding upside down under a dash while laying on the floor is harder than it sounds. Please also excuse the shit pictures.
Notched my column bracket for the booster rod, again... this was hard as hell and could have definitely wound up cleaner. However, it works and will be hidden under the dash. Phew.
At the same time you'll see the pivot is back for the bell-crank. I need to build the top bracket for it but I want to verify that my travel will be sufficient before I make it a final thing.
I also ordered three spherical ball pivots (I can't think of the not retarded name for them at the time... brain has turned to mush). They should be here near the end of the week and thusly I can finish my brake setup.
Also, got bored... half-ass primered my bay.. it might actually look decent when body-worked.
K, think that's it?
I need to start hauling ass on this thing. May 25th is coming way too fucking fast.
Comment