If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Cut, fit and tacked the roll bar in. Went a lot smoother than expected. Plan on welding and prepping it for paint this week.
HUGE thanks to my friends Clay and Shaun (vgrnt)!
Even though it's not fully welded, I can already tell a difference in the chassis. Much more solid and it eliminated some flex/shimmy that would shake the soft top.
Actually think it would look even better with a bit less poke in the front and slightly more low up front or a bit more in the rear along with slightly raising the rear.
Front poke and lows can't really be changed, as the specs are 17x10 et15. The rear is still at et30, so I plan on getting camber arms and around 15mm spacers to get it sitting better.
Actually think it would look even better with a bit less poke in the front and slightly more low up front or a bit more in the rear along with slightly raising the rear.
You polished the insides "just cause" Well, wanna be my friend? I got a full set that needs re-polishing.
Looks amazing, cant wait to see what you come up with. Oh, might have missed it but 215/40's?
lol, if you've ever seen pics of my wife's car, it could definitely be that I just have an addiction to polishing. Thing is, I absolutely **** doing it.
Leave a comment: