Hey all!
I've got quite a bit done to the car already but its my no means "finished". I've had the car for about 3 years now and have slowly worked up to where it is now. This IS my DD.
Current mod List:
Engine/Drivetrain:
Stock L24
3x Weber carburetors 45 DCOE (In Progress)
MSA aluminum radiator + dual electric fans
5 speed transmission
R200 welded differential
Suspension:
T3 front + rear weld in camber plates
T3 front + rear LCA
T3 roll center adjusters
T3/ Ground Control full weld on coilovers
Eibach Springs: F - 350lbs / R - 300lbs
T3 tension control rods
Tokico HTS AE86 cartridge short stroke shocks
Energy Suspension Polyurethane bushings
Suspension Techniques front + rear sway bar
Exterior:
rolled+pulled fenders
classic style hid projectors
front air dam
rear spoiler
Interior/System:
Recaro "Renoma" seats
Crow Enterprizes 4-point harness
Autopower rollbar (custom powdercoated candy purple)
Momo Hub
Works Bell quick release + flipper
Nardi Deepcorn 350mm leather steering wheel
Boston Acoustics SC55
Boston Acoustics SC95
Alpine Type R 10" Sub
Alpine MRX-M100
Alpine MRX-F30
Clarion VX401
Wheels:
Work Equip 03 "StarRoad Replica"
Front - 15x9 -16 Yokohama S-Drive 195/55R15 -4 Camber
Rear - 15x10 -28 Yokohama S-Drive 205/55R15 -6 Camber
The audio is being redone and after it gets back from JCCS in September the motor is going to start being built.
MORE PICTURES TO COME!
Previous setup:
Current setup pre-alignment:
Any and all feedback greatly welcomed!
-Sunny
I've got quite a bit done to the car already but its my no means "finished". I've had the car for about 3 years now and have slowly worked up to where it is now. This IS my DD.
Current mod List:
Engine/Drivetrain:
Stock L24
3x Weber carburetors 45 DCOE (In Progress)
MSA aluminum radiator + dual electric fans
5 speed transmission
R200 welded differential
Suspension:
T3 front + rear weld in camber plates
T3 front + rear LCA
T3 roll center adjusters
T3/ Ground Control full weld on coilovers
Eibach Springs: F - 350lbs / R - 300lbs
T3 tension control rods
Tokico HTS AE86 cartridge short stroke shocks
Energy Suspension Polyurethane bushings
Suspension Techniques front + rear sway bar
Exterior:
rolled+pulled fenders
classic style hid projectors
front air dam
rear spoiler
Interior/System:
Recaro "Renoma" seats
Crow Enterprizes 4-point harness
Autopower rollbar (custom powdercoated candy purple)
Momo Hub
Works Bell quick release + flipper
Nardi Deepcorn 350mm leather steering wheel
Boston Acoustics SC55
Boston Acoustics SC95
Alpine Type R 10" Sub
Alpine MRX-M100
Alpine MRX-F30
Clarion VX401
Wheels:
Work Equip 03 "StarRoad Replica"
Front - 15x9 -16 Yokohama S-Drive 195/55R15 -4 Camber
Rear - 15x10 -28 Yokohama S-Drive 205/55R15 -6 Camber
The audio is being redone and after it gets back from JCCS in September the motor is going to start being built.
MORE PICTURES TO COME!
Previous setup:
Current setup pre-alignment:
Any and all feedback greatly welcomed!
-Sunny
Comment