If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hey man, I have a question: what's the exact function of those reinforcement plates for the rear shocks?
And what do they look like? I can't seem to figure out what it does exactly...
Here is what the painter and I did yesterday. 10 hours of work, lots of "Fuck you"'s and a few screws leftover later i finally have a full-coloured car again:
What i need in fact are tires which have good stretch, rolled fenders, maybe some negative camber in the rear and a good idea what to do with my fucked up left front.
the fender is 100% stock.
when i was running the rear, it was 205/40 on a 9 et22. were the fender was rolled, with out removing the sealant. now its a 10" with 215/40.
you can check my build thread v2 and see when i was running the 9inch wheel.
Leave a comment: