Das V8 Coupe Quattro

[dspl1236]

Freaking awesome, glad to see some progress on the design I'll be checking back at the end of the week for some real life pictures.

wowowow too cool
how many axes is that cnc?
subscribed!!

Both have 3-axis, the one closer in the photo has 4-axis capability...but no hardware....and just was sold and picked up... a new VF-5 w/4th axis installed is being built by haas right now. delivery is set for first week of jan. also its been 14 weeks on the new haas cnc lathe...will be done in feb i think.

Awsome project.

[mshriver]

Wow just read all of this. Amazing build!

[electricalbox]

The suspense is killing me!!!!!!!!!!

[Shawn W.]

in for progress

[NeedingAnAudi]

less rendering more manufacturing.

[sumpcracker]

Set of 4 on open trumpets.

[dspl1236]

set of 8

too close. v5 is already in the works

[dspl1236]

nowhere to put velocity stacks!



to the garage!

[dspl1236]

would be sweet....

this is the fixed version v4.2. intake flange faces and block width are now correct. still have not made a shorter/easier to machine v5 flange yet....

[dspl1236]

waiting on my buddy to get his new cnc setup.

'91 MR2 Electric P/S Acquired

[dspl1236]

back to fabricating...need to cut out a section of the rear floor. while i was at pull a part wandering around looking at radiator and electric fan setups and warming my hands...saw some great ideas...then got back to the mr2 i was working on and finally made up my mind on a rear mounted radiator. Toyota did a nice job on that mr2 in its mid engine design. neat little car...just will never own one.

[dspl1236]

[NeedingAnAudi]

waiting on my buddy to get his new cnc setup.

'91 MR2 Electric P/S Acquired

Wonder how hard this would be to install on my B5

[dspl1236]

Wonder how hard this would be to install on my B5

i do not thin k it would be too bad to do. i have heard the audi to toyota high pressure line is the hardest part. i am just going to go a a hydro line shop when i am ready

[dspl1236]