Announcement

Collapse
No announcement yet.

Eurowise Project 500hp turbo awd 1984 rabbit GTI

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • eurowise
    replied
    Originally posted by nothers View Post
    Mike it's Warren. Did you cut up his mk1 floor pan yet? If not, how bad is it? I need it for my rabbit, mine is completly rotted away. Tell the owner i'm not paying for it either .
    Warren how you doing buddy? frame rails were pretty mangled from being low, I also think someone already has dibs on them as well. i will find out and let you know sir.

    Leave a comment:


  • nothers
    replied
    Mike it's Warren. Did you cut up his mk1 floor pan yet? If not, how bad is it? I need it for my rabbit, mine is completly rotted away. Tell the owner i'm not paying for it either .

    Leave a comment:


  • euro e28
    replied
    this is what custom is all about. my hat goes off to you guys.

    Leave a comment:


  • 90probef2t
    replied
    This is Car customizing at its Best. Build your own. My hat to you..

    Leave a comment:


  • lilcraigford
    replied
    This build is insane! I am going to be following this for sure. Incredible craftsmanship and attention to detail.

    Leave a comment:


  • jpod999
    replied
    I bow down to these fab skills.

    Leave a comment:


  • eurowise
    replied
    On to the rear end. Measuring from hub to hub the r32 is 2.5 inches wider than the rabbit suspension. The plan of attack will be to shorten the control arms, the axles, and narrow the r32 floor pan so everything will bolt up and fit just like an oem r32 suspension. even the rear spring seats will fit in the OEM pockets.

    shot of the rear upper control arm before modification



    shot after shortening to show how much will be removed from each side



    the inner control arm was cut offset so the caster was back to spec



    top angle showing the control arm installed with the offset modified. notice the axle sits straight now





    shot of the adjustable lower control arm



    machined and sectioned 2.5 shorter and will be tig welded back together.





    For mockup we modified the factory axles until proper length was achieved. After we're happy we'll have custom axles built to withstand the horsepower goals the customer wants.

    passenger side axle shortened.



    Leave a comment:


  • stig
    replied
    Let me just pick my jaw up off the floor...

    Leave a comment:


  • 180roman
    replied
    fark that a lot of fabrication

    props to you sir, amazing build

    Leave a comment:


  • Curt_pnw
    replied
    Mind = Blown.

    Nice work guys, this is amazing stuff. With a little imagination and a shit ton of fabrication skill, anything is possible. lol

    Leave a comment:


  • Vegas13
    Guest replied
    What the fuck just happened to my brain!!!!!

    Leave a comment:


  • Tuck&Poke
    replied
    holy shit, this just might be my new favorite build thread

    Leave a comment:


  • ThatEF9kid
    replied
    that is insane, i cannot wait to see this finished, it will be panty dropping

    Leave a comment:


  • Chase Otter(:
    replied
    my pants are wet... very very wet.

    Leave a comment:


  • eurowise
    replied


    thanks for the props guys. We will keep the thread updated!

    Leave a comment:

Working...
X