If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Still waiting on parts for the exhaust build, so as I was bored, I decided to testfit my new wheels.
Only at the front though, as I know there'll be lots space at the back.
9x16 ET25 5x100
Full contact on the caliper bracket.
No contact on the caliper, but very tight fit. Might need to run 5mm spacers with new brake pads (60% right now).
Took off 2mm of material on the bracket, now the wheels can be turned without any contact.
Maximum camber the stock screws on the struts give you already made the lips sit flush.
Maximum camber through a uniball top mount gave me quite some space... guess I might not be running 9Jx16 on this car then.
@enes_ca
No need for camber plates!
It's an AWD Golf and that's the camber you get only from lowering it.
@Justinfbi
No updates unfortunately.
Progress is rather slow as I gotta wait for a friend who's helping me build the custom header.
There's just no stock part that'll fit and space is pretty tight, so it's taking its time. Once that's done things should progress faster again.
Comment