If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
How much Harv? Damn you I just purchased a new motorvehicle!
Jorge, one set is in Shropshire and the other is in Doncaster. Not sure which ones yet. If they will end the auction then no probs I'll get them on Sunday
it's over 5cm out the cars arches, rivet arch kits look shit and im not going to get that much out of them, i've already found a replacement. its all good.
Speedhunters is an international collective of photographers, writers & drivers with a shared passion for uncovering the world's most exciting car culture stories.
I've tried to tell him he is being gay but he won't listen. I want to buy them just to prove the point.
8J ET0 sits about flush, maybe 1-2mm in from arch (no camber)
9J ET0 will poke about 12.5mm more, so about 10/11mm poke, then add the offsets.
9J ET-19 30mm poke. Which to me sounds perfect.
A few degrees of camber would easily bring that to 10-15mm, with just a slight stretch they'd fit like a glove. Without even touching the arches.
Comment