If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
So good, much nicer then mine that's for sure.
Nuts that 3 of our group rocked up with them though
Sarcasm is easily calculated on vortex dude. Take 4 parts GLI lip and divide by BBS RS. If you are left with a remainder, subtract it from omgmoarlow. Profit.
just ran across this post on another forum about tumblers, interesting to see his 2-stage setup, cleaning first then polishing with different media...
Iv been slack about building my tumbler for ages but I just had time to do it today and now I'm having trouble finding where to buy that plastic triangle media for it in Australia any thoughts on it? Or do you think that's a ceramic media?
Will only ship internationally if I have an account with Bongo? Which means I'll have my own U.S. address. Not got bother now since it ends in 14 hours.
Will only ship internationally if I have an account with Bongo? Which means I'll have my own U.S. address. Not got bother now since it ends in 14 hours.
spew, could sign up for a freight forwarder in the states. its what the missus did when they would ship internationally.
thanks mate. Kinda worried that the holes for the valve stem seals have been enlarged a bit much when I got the lips polished, hope they seal. Also what do I use to hold the back of the valve stem from spinning while I tighten the nut on the front? There's no hex or anything back there (genuine Work stems).
Comment