If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
LOL its the inner clearance I'm concerned about.
I put the 16x7.5 et30 and it had like 2/3 of an inch clearance from my suspension.
Also it would end up being 16x11 et 24 (with 7" barrel and 3.5" lips) or 16x10 et 0. (with 5.5" barrel and 4" lips).
Fuck I gotta start a clothing company. Fucking.... people make loot on that shit. A shirt that literally just says "illest" in cursive letters.... prob cost $5/shirt. Sells for $30.
2/3 of a " is cool, all you need is 3-4 mm to acct for camber on compression. Try and mock em up with the 7's you never know.
Even if they do fit, they are actually going to have less poke and less lip than the 10" setup that I want.
Also I'd have to consider what I would pair it with on the front, if I go with an 11" rear that means its going to be an 3.5" lip. So with the fronts I'd have to go 9.5" or smaller, otherwise I'd have a bigger lip on the front.
Fuck I gotta start a clothing company. Fucking.... people make loot on that shit. A shirt that literally just says "illest" in cursive letters.... prob cost $5/shirt. Sells for $30.
Let's start one together <3
We can print silliest on em
Even if they do fit, they are actually going to have less poke and less lip than the 10" setup that I want.
Also I'd have to consider what I would pair it with on the front, if I go with an 11" rear that means its going to be an 3.5" lip. So with the fronts I'd have to go 9.5" or smaller, otherwise I'd have a bigger lip on the front.
Wait wut?
If the lip stays the same it shouldn't poke less, you'll only have a wider barrel so your offset goes up, but your face doesn't move nor does the lip. Unless I read something wrong.
Comment