If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Check for leaks
try and figure out wtf is going on with the passenger side wheel when I go over 80
raise the rear subframe
try and fix the swaybar endlinks
Check for leaks
try and figure out wtf is going on with the passenger side wheel when I go over 80
raise the rear subframe
try and fix the swaybar endlinks
LS leaking oil? or PS leak?
You going with solid risers? how come you didn't put them in earlier, they are so good for leveling out the LCAs.
GKTech is in the process of changing their design atm.
I know that PBM has a 25mm rear drop knuckle WITH spherical bushings, and those are 400 IIRC.
they even have a dual caliper option....
Wouldn't say Driftworks suck, they probably do their job pretty well, but as my friend found out, they are not a direct bolt on.
He had to grind some corners as they were fouling the rotor or the LCA, can't quite remember which one. And their powdercoating is terrible and falls off almost instantly.
Its just for how much money those things cost, they did not stand up to their value.
Comment