245/40/17 ET40 on rear of E36

[chapel]

Any need to roll the fenders for this fitment?

[chapel]

yep... just a little I think. but it is rubbing.

[Tommy604604]

That's close to stock M3 spec. depending on how wide the wheels are.

[chapel]

Oh jeez. I forgot to put the width... 17x9

[chapel]

http://imgur.com/a/TdTSp

I'm hoping with some heat and an eastwood fender roller, I can get a quarter to a half inch of clearance here...

[Zic]

I had 255/40 on a 17×9 et22 with rolled fenders and no rubbing. Tho I did a really good roll job.

[Zic]

Was on stance works coil overs and uuc camber arms, running around -3 degrees of negative camber. (You can get close to that on stock camber arms)

[chapel]

pulled the fenders...

cracked the paint on one side...




I'll get some touch up paint and glob it on. It's on the edge.