fittipaldi wheels-fine tuning

[mk3f.t.w.]

I want to make my front wheels fit a bit better. They poke a bit too much. I would like them flush or tucking. Unfortunately I have the thinnest adapters I could get at the time from adaptec speedware (15mm). Then I machined the front wheel pads a few mm to bring them in. And I have h&r camber bolts maxed out.

I am looking for peoples opinions based or previous experience please. Whtever is cheapest is what i will do haha. I want to run the wheels again, and have them fit well, but really broke right now.

Some of the solutions i came up with:

1) Run golf/mk2 suspension to narrow the front track of the vr plus suspension (I already have mk2 control arms, tie rods, and one axle)

2) Get camber plates up top

3) Find thinner adapters

4) Fill n drill wheel and run small spacers

5) find new front lips (most likely custom due to 15" center on 16" wheel)



note the front pork

[scubagli]

You can't use 4lug control arms and keep your 5lug hubs...get the wheels re drilled to 5x100....

[P78]

camber plates or new lips

don't redrill

[mk3f.t.w.]

Thanks. I just lowered my car more and they seem to fit better haha

[mk3f.t.w.]