If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Had a meet on this past Sunday that I thought I would go along too, I had never been to one before (held monthly) and was astounded at the 800+ cars in attendance !! Was lucky enough to get a few photos, first one actually made it Into the official blog write up of the event! Super stoked people are digging what ice done. Minitrucks are normally ***** on in Australia.
Needs spacers and paint!!! Hopefully before Christmas
3rz. Have a steampipe manifold with a gt35/40, rx7 550cc injectors ready to go on, just need a cooler and computer to run it all and get all the pipe work made up.
Have a spare 3rz I'm building on the side. Is getting forged rods and pistons, stock valves with reworked valve seats and a mild polish. Stage 2 kelford cams. One off forward facing intake manifold with edlebrock 75mm throttle body, one off exhaust manifold with external wastegate feed for a 45mm gate. Gt35/82r turbo.
It will use the 550cc injectors plus a duel feed fuel rail that gets fed by 2 litre surge tank and a Bosch 044 pump.
3rz. Have a steampipe manifold with a gt35/40, rx7 550cc injectors ready to go on, just need a cooler and computer to run it all and get all the pipe work made up.
Have a spare 3rz I'm building on the side. Is getting forged rods and pistons, stock valves with reworked valve seats and a mild polish. Stage 2 kelford cams. One off forward facing intake manifold with edlebrock 75mm throttle body, one off exhaust manifold with external wastegate feed for a 45mm gate. Gt35/82r turbo.
It will use the 550cc injectors plus a duel feed fuel rail that gets fed by 2 litre surge tank and a Bosch 044 pump.
Man I wish I could even find a extra motor. I prefer the 2rz for the faster rev and that it don't have balance shafts. Did you remove yours yet? I want to get a 3rz and d stroke to 2.5 or stroke a rz to 2.5.I'm gonna get a new mani from santos.screen shot off ct. I also have a megasquirt 2 for mine I have greddy 720s but I'm not sure it can fit. And a Garrett 60-1. I just can't start building too crazy since this is my work truck lol, I need it up and running mon-friday
Screen shot off the forums
Comment