Announcement
Collapse
No announcement yet.
Stanced Trucks?
Collapse
X
-
Comment
-
Originally posted by Wildman Productions View Post
Comment
-
Originally posted by way2fastx3 View PostEvery think about doing a 2gen front end conversion? Like mine.
might be gettin 17's here soon
Comment
-
Originally posted by Wildman Productions View PostI might do a 98+ sonoma bumper, but I **** the s10 fronts
might be gettin 17's here soon?? But i will tell you this... Im on a 17 x9 wheels with 4.500in backspacing and i rub my inner frame rails. Its not a horrible rub but im just letting you know now. Its enought to grind it down to the metal but NOT create groves in the frame if u get my drift. Im going with a new fitment next spring anyway. Im also on a meat tire since its my daily driver and the roads here in PA are the worst around. What fitment were you looking at shooting for?
Comment
-
Untitled by way2fastx3, on Flickr
Heres where im rubbing. Its the same on both sides. And the Alignment is not off either.
Comment
-
Originally posted by MitsuMax View PostCut teh bumpstop tabs off and that got me lower :P
Too bad my drop isn't even : half inch off on one side, oh well its all goodmy clearance is less than that brick!
Comment
-
My truck fucked me out of going to a show for the last time. (This time it was Wekfest). So its on CL for sale. Is there anything I should know about going stupid low static on an S10? I want to rock 15x9s or 15x10s on it.
So far I've found 3" drop springs, and 2" drop spindles. I figure that + putting 215/50/15's on some 15x9's should give it a nice stance. It'll be a SCSB 4cyl.| 92 Corolla AE92 | HKS SMF, Testpipe, Hyperco/Tokico/GC | Houston, TX | 86Garage |
Comment
-
Originally posted by kaidotech View PostMy truck fucked me out of going to a show for the last time. (This time it was Wekfest). So its on CL for sale. Is there anything I should know about going stupid low static on an S10? I want to rock 15x9s or 15x10s on it.
So far I've found 3" drop springs, and 2" drop spindles. I figure that + putting 215/50/15's on some 15x9's should give it a nice stance. It'll be a SCSB 4cyl.
Comment
-
Originally posted by kaidotech View PostMy truck fucked me out of going to a show for the last time. (This time it was Wekfest). So its on CL for sale. Is there anything I should know about going stupid low static on an S10? I want to rock 15x9s or 15x10s on it.
So far I've found 3" drop springs, and 2" drop spindles. I figure that + putting 215/50/15's on some 15x9's should give it a nice stance. It'll be a SCSB 4cyl.
Comment
Comment