18X8 ET14.5 Speedline Alessios 5x120.65

[Bullydawg]

I have a set of 4 that are all 18x8 ET 14.5. They need to be stripped and restored. I have already done one set for my car and decided to let this set go. The lips appear to be in good shape. Some of the inner barrels have a flat spot. I ran one on the set I restored and it didn't affect the balance. Purely cosmetic and on the inside so nobody would see it.

Asking $1400 + shipping. You can readily buy new lips from felgenfuch and resell these lips/barrels to recoup most of your money.

[Bullydawg]

Far right set of wheels. The gold ones are the ones I restored for my car.

[Bullydawg]

TTT. Rare wheels! Especially in this bolt pattern! Get these on your BMW using wobble lug nuts!

[Bullydawg]

Bump.

[Bullydawg]

TTT. $1200 + shipping!

[Bullydawg]

Ttt.

[Hawke]

TTT. $1200 + shipping!

I'm interested in your OZ wheels. PCD and offset are fine, but I need a measurement of the hub bore. Ideally, it would be about 74mm, but I'll bet it's smaller than that. Can you send a photo of the back of the wheel hub so I can see if machining the hub bore is a possibility?

Thanks.

[Bullydawg]

Unfortunately I am not selling any OZ wheels.

[Hawke]

Unfortunately I am not selling any OZ wheels.

Sorry. I meant your Speedline Alessios. But same question regarding the hub bore dimension...

Thanks.

[Hawke]

So, have you sold the Speedline wheels??? If not, please respond.

Thanks.

[Bullydawg]

Hub bore looks to be around 72mm... it looks like machining to 74 would be pretty likely. The beveled part looks to be about 3-4MM...IMG_2225.jpg

I am out of town monday-friday, so I am only home on the weekends.

[Hawke]

Hub bore looks to be around 72mm... it looks like machining to 74 would be pretty likely. The beveled part looks to be about 3-4MM...[ATTACH=CONFIG]17314[/ATTACH]

I am out of town monday-friday, so I am only home on the weekends.

No problem. Might be able to make this work. But I am a bit confused about flat spots on the inner barrels. Can you explain? Does that mean that they are out of round? It would seem that it would tale a helluva impact for that to happen... Contact me at jchoren@frontier.com if it'd be easier to discuss this outside of the forum. Thanks.

[Bullydawg]

Email sent.

Any good wheel shop can fix flat spots for about $50 a wheel for anyone else wondering.

[Hawke]

No problem. Might be able to make this work. But I am a bit confused about flat spots on the inner barrels. Can you explain? Does that mean that they are out of round? It would seem that it would tale a helluva impact for that to happen... Contact me at jchoren@frontier.com if it'd be easier to discuss this outside of the forum. Thanks.

You sent some additional photos to my email address which were inadvertently deleted. Can you resend?? Thanks.

[Bullydawg]

Gone!