Tweet
SOLD
I'll make this very clear:
I want these gone!
17x8 et15 square
2" lip, 6" barrel, welded
5x120 pcd
72.56mm center bore
Stern reverse face 2 wheels are very uncommon in BMW fitment; most were 5x114 and/or the 5 spoke version.
The face size is perfect if you want to step them up to 18" using AMC double step lips. There are several places that will source the blanks and have them cut/drilled. I was quoted about $1400 for 18x9/10.
-Silver painted centers and caps (urethane basecoat/clearcoat). Matched to the original color, which is a very fine metallic flake.
-Polished bolts and black painted nuts. Threads should be chased with a tap and die to clean up the old loctite.
-Polished valve stems.
-Glass bead blasted lips.
-One barrel has the slightest bend on on the back side. It's about a 1 to 2mm dip over a 2 inch length... very hard to find. It's marked with an arrow on the barrel.
SOLD
Two of the centers were mostly pressed back in but wouldn't budge the last couple millimeters. These obviously require some sort of witchcraft I don't understand. I pounded them back out. These have been the refinish from hell, and I just want them out of my sight. At $1000 shipped I break even. Offer me less. SOLD for $600
Full album:
I'll make this very clear:
I want these gone!
17x8 et15 square
2" lip, 6" barrel, welded
5x120 pcd
72.56mm center bore
Stern reverse face 2 wheels are very uncommon in BMW fitment; most were 5x114 and/or the 5 spoke version.
The face size is perfect if you want to step them up to 18" using AMC double step lips. There are several places that will source the blanks and have them cut/drilled. I was quoted about $1400 for 18x9/10.
-Silver painted centers and caps (urethane basecoat/clearcoat). Matched to the original color, which is a very fine metallic flake.
-Polished bolts and black painted nuts. Threads should be chased with a tap and die to clean up the old loctite.
-Polished valve stems.
-Glass bead blasted lips.
-One barrel has the slightest bend on on the back side. It's about a 1 to 2mm dip over a 2 inch length... very hard to find. It's marked with an arrow on the barrel.
SOLD
Two of the centers were mostly pressed back in but wouldn't budge the last couple millimeters. These obviously require some sort of witchcraft I don't understand. I pounded them back out. These have been the refinish from hell, and I just want them out of my sight. At $1000 shipped I break even. Offer me less. SOLD for $600
Full album:
Comment