3pc Zauber Starform 17x8/9 Low Offsets!

[fahrenheitfarmer]

Zauber Starform Monoblocks
5x114.3
17x8 et -1
17x9 et 13

Picked these up with the intent to split and refinish, but offsets are way out of my league. I think there are many more people here who could properly run these.

They're dirty, sure, but they certainly look great once refinished. Small dent in the lip of one of the fronts, but held air just fine and can be fixed for $50 at any wheel repair place. Otherwise, no bends or cracks at all. I went to split one and underneath the silicone bead, they are welded. I've got a hookup at Adaptec that can fill-n-drill these for $50/wheel, making it to where you can mill down the backpads to make much higher offsets.

Extremely hard to find these in such low offsets. $800 shipped anywhere in the lower 48. Open to trades for less aggressive offset modular wheels. I'm in the process of taking out all the bolts, polishing them, and cleaning the wheels completely.

Before and After:

[fahrenheitfarmer]

Splitting these tomorrow, open to offers!

[fahrenheitfarmer]

changed some info, lowered the price

[ToPLeSS(e30)FienD]

damn those offsets, no room for adapters.. awesome wheels. would have bought these if i didnt just pick up another set. GLWS. these look good on just about anything

[HWY HNTR]

Where are you located? I would love to test fit these if you're kinda local before I buy them. Also you said that they are welded together? So you would need to cut them to make the 3 piece again I'm assuming? Are they all like that? or just the one that you took apart so far?

[fahrenheitfarmer]

I've only tried to split one of the wheels, and it was a rear. It's a safe bet to assume they are all welded, but I can easily remove all the silicone if you wanted the assurance. You could have the welds peeled up by someone good at welding or you could do it the ghetto way and carefully use a cutoff wheel to cut the weld. It looks like a factory weld though, but baffles me as to why it would have silicone around it. Here's a photo of the weld:



I'm not exactly local, I'm in Cincinnati. But if these don't sell in the next couple of days, I'm gonna completely refinish them myself and they'll be over $1200 after all the work.

[fahrenheitfarmer]

Up top, cleaning the other wheels.

[fahrenheitfarmer]

My hands hurt from cleaning these. $700 shipped?

[fahrenheitfarmer]

up top!

[fahrenheitfarmer]

Dropping a wheel off at powder today to play around with some colors. Last chance before finishing them.

[neverlowenough]

Let me see if i can dig to get some cash for these. Ive been looking for a set.

[CandySucker]

these look like a great project...too bad I don't see how anyone could use these looking at those offsets

[fahrenheitfarmer]

They're good VIP fitment, as well as S-chassis fitment. Again, for just $200, you can make the offsets on these about anything you wanted.

I'll have pictures of one wheel powdercoated on Friday, and if not sold, I'll do the rest of them and polish out all the bolts.

[MikeyRa]

So. Much. Want.

[HWY HNTR]

I sent you a Pm