Tweet
05-07 STI Application [w/ less than 2k miles]
Air Lift Performance Struts [Front & Rear]
- Front PN: 75551
- Rear PN: 75651
AccuAir Switchspeed Management
- AccuAir VU4 Manifold
- AccuAir Switchspeed ECU
- AccuAir Switchspeed Controller [Black Finish]
- AccuAir Wiring Harness
- 200 PSI Digital Pressure Sensor [for tank]
- Viar 400C Compressor w/ Silencer & SMC Check Valve
- Black Anodized 3 Gallon AVS Aluminum Air Tank
- Water Trap & All Necessary Fittings [3/8 Inch Lines]
- Underwraps Automotive Power Kit
Zaetech DigiGauge Pressure Display
- DigiGauge ECU
- Full Plug-n-Play Wire Harness
- 5 200 PSI Digital Pressure Sensors w/ Reducers For Use In VU4 Manifold
- LCD Display Screen w/ Black Anodized Aluminum Bezel & White LCD
- 25ft Display Harness
Notes
The install was done with the intention of completely hiding the air suspension components. As a result, the entire setup fits neatly in the spare tire well on a circular base of 1/2 inch plywood. It uses the spare tire tie down to secure it to the floor. If desired, the setup can remain complete for ease of installation into the next vehicle.
I would like to get $3,200 shipped for the kit. It is is new condition. However, I would prefer local pickup. I am located on Long Island, NY.
Photos:
Thank you for looking.
Air Lift Performance Struts [Front & Rear]
- Front PN: 75551
- Rear PN: 75651
AccuAir Switchspeed Management
- AccuAir VU4 Manifold
- AccuAir Switchspeed ECU
- AccuAir Switchspeed Controller [Black Finish]
- AccuAir Wiring Harness
- 200 PSI Digital Pressure Sensor [for tank]
- Viar 400C Compressor w/ Silencer & SMC Check Valve
- Black Anodized 3 Gallon AVS Aluminum Air Tank
- Water Trap & All Necessary Fittings [3/8 Inch Lines]
- Underwraps Automotive Power Kit
Zaetech DigiGauge Pressure Display
- DigiGauge ECU
- Full Plug-n-Play Wire Harness
- 5 200 PSI Digital Pressure Sensors w/ Reducers For Use In VU4 Manifold
- LCD Display Screen w/ Black Anodized Aluminum Bezel & White LCD
- 25ft Display Harness
Notes
The install was done with the intention of completely hiding the air suspension components. As a result, the entire setup fits neatly in the spare tire well on a circular base of 1/2 inch plywood. It uses the spare tire tie down to secure it to the floor. If desired, the setup can remain complete for ease of installation into the next vehicle.
I would like to get $3,200 shipped for the kit. It is is new condition. However, I would prefer local pickup. I am located on Long Island, NY.
Photos:
Thank you for looking.
Comment