Tweet
Since the full set of 505's has sold and there has been some confusion on what parts are left, I decided it would be best to make a new thread, in the correct sub-forum, showing only the parts that are still available.
These parts should fit any USA HRE 16" 20 hole wheels including 501, 504 and 505 among others.
The inner diameter (ID) of the parts is 12". If you have Japanese HRE or Hayashi wheels with 12 3/4" ID these will not work, however I do have access to some Hayashi parts. (4) 2.5" lips, (2) 5.5" barrels, (2) 6.5" barrels.
The USA HRE parts I current have are as follows;
(2) - 505 centers 5x130 re-drilled to 5x114.3 - SOLD
(2) - 2" lips - SOLD
(2) - 5.5" barrels - SOLD
(2) - 6" barrels - SOLD
Centers
(2) - 5x130 505 centers. These centers have been redrilled to 5x114.3 and the plugs have been removed. I would recommend filling completely and re-drilling before using.
These are also stripped, not acid dipped and are in decent condition.
Lips
(2) - 2" lips - Good condition. Some scratches can be seen at 1'. Both have been wet sanded from 400, 600, 800, 1000, 2000 then machined buffed and polished.
Barrels
(2) - 6" barrels - Decent used condition. One of the 6" barrels was cracked as shown in the parts ad I previously had and in the this picture. http://i35.photobucket.com/albums/d1...e/IMG_1366.jpg
This has been welded in and smoothed out. All have been sanded to 100 grit and are ready to paint or powder-coat
(2) - 5.5" barrels - Decent used condition. Dirty and a few flat spots but should balance fine.
These parts should fit any USA HRE 16" 20 hole wheels including 501, 504 and 505 among others.
The inner diameter (ID) of the parts is 12". If you have Japanese HRE or Hayashi wheels with 12 3/4" ID these will not work, however I do have access to some Hayashi parts. (4) 2.5" lips, (2) 5.5" barrels, (2) 6.5" barrels.
The USA HRE parts I current have are as follows;
(2) - 505 centers 5x130 re-drilled to 5x114.3 - SOLD
(2) - 2" lips - SOLD
(2) - 5.5" barrels - SOLD
(2) - 6" barrels - SOLD
Centers
(2) - 5x130 505 centers. These centers have been redrilled to 5x114.3 and the plugs have been removed. I would recommend filling completely and re-drilling before using.
These are also stripped, not acid dipped and are in decent condition.
Lips
(2) - 2" lips - Good condition. Some scratches can be seen at 1'. Both have been wet sanded from 400, 600, 800, 1000, 2000 then machined buffed and polished.
Barrels
(2) - 6" barrels - Decent used condition. One of the 6" barrels was cracked as shown in the parts ad I previously had and in the this picture. http://i35.photobucket.com/albums/d1...e/IMG_1366.jpg
This has been welded in and smoothed out. All have been sanded to 100 grit and are ready to paint or powder-coat
(2) - 5.5" barrels - Decent used condition. Dirty and a few flat spots but should balance fine.
Comment