front ride height question

[pattshreds]

i have the reverse rake look, how would i make the front lower?
i hear B5s upper control arms hit the top of the fender and people cut out a hole where they hit?

anyways, all the way aired out i have about two fingers in between the wheel lip and fender,
but id like the fronts to tuck.

any input on this?

[Byron]

Exactly what you said, you need to cut a hole. Air it down all the way then bounce on the front, then raise the car and look at the dents for ideas where to cut. You need to cut quite a bit in order to tuck.

It's a good idea to box in the hole once you get it cut correctly, both for structural integrity and to keep the engine bay clean.

[pattshreds]

oh i know where the dents are, the control arms hit everytime i air out and if im driving low enough they hit when i go over a bump, just wanted to make sure that was true about cutting a hole out, thanks man!