Need some help!!!!

[JermyZ]

So i got some wheels for my Z, well just 1 wheel to test fit, thankfully i did. the wheel really fits great but i have just one concern:







there is about a 1 finger gap where the arrow points so the wheel is ONLY being held on by the wheel studs. Is there a way to fix this problem? or am i just shit outta luck and should be thankful i only bought one wheel?

[Zic]

Buy some hub-centric rings. And you are good to go.

[JermyZ]

where would one go about getting thems? and what size to get? lol. and how do i know how big of one to get?

[JermyZ]

heres a little sneak peak of how they fit:

[s4cr]

Hubcentric rings have two measurements..so basicaly what you need is to know the diamer of the hole on the rim, and the diameter of cars center bore. (it's 66.1 on Z's if i'm not mistaking)

[JermyZ]

Hubcentric rings have two measurements..so basicaly what you need is to know the diamer of the hole on the rim, and the diameter of cars center bore. (it's 66.1 on Z's if i'm not mistaking)

Yeah 66.1 is the z hub but my wheel had a very larg
diameter haha. It took a bit cause the outer diameter had to be 83.82 (3.30") an inner is 66.1 haha. But I found some and they should be here soon.. I hope

[BreakMyWallet]

the question has already been answered, but these wheels are gonna be pretty sunk in once the car is on the ground. i wouldnt expect it to poke like that, fyi.

what wheels are those by the eway? they look like those truck wheels by unique design.

[nateee]

youll be fine......

[fixdaserver]

Hubcentric rings

I have the same issue. where did you end up buying the 66.1 to 83.82 hub centric rings? I'm having trouble finding this specific ring size.