Volk Meshies on a Caddy

[willshaffer]

Hey guys, new to the caddy and now new to the 3-piece wheel world. Anyway, getting a mk1 caddy soon and a set of rays volk meshies, 14x6 (offset is et19 i think) and my question is, should i get the wheels redrilled to 4x100 or should i just run an adapter? wheels are 4x112. im worried that running an adapter will give me too much poke.
volk .jpg
These are the wheels. getting them all cleaned up and powder coated soon

[P78]

wobble bolts?

[Dr.AK]

wobble bolts?

I doubt that's going to work to compensate for the difference between 4x112 and 4x100.

[nayton]

other option is shaving the back pad of the wheels and then - spacers

[KyleAnderson]

They're only 6" wide, so you should have room for an adapter.

[LowElementStar]

A redrill can help avoid the poke and possibly running spacer to compensate.

[Tuck&Poke]

Doesnt look like you have a lot of room to redrill. I would say adapters or nothing.

[I_R_5m4r7]

I have 14x6 et38 snowflakes with a 1/2 spacer due to the drop plates and its nearly an inch from flush. I would say at et19 and a 1/2 inch adapter you will be right aroundflu sh or have just a little poke. Either way, dope wheels for sure. If ucan t figure it out ill put em on my caddy :P

[SourKrowt]

adapters dont redrill a original set to make them fit for this situation

[I_R_5m4r7]

4x100 to 4x112 is 12 mm.....wobble bolts wont work

[zoo]

4x100 to 4x112 is 12 mm.....wobble bolts wont work

I cant read, apparently.