Borbet A centre caps issue

[Shieldsy94]

Hi, i have some Borbet A for my fiesta (4x108 pcd) and I've ran into a fairly big problem.

Anyways, bought the wheels with no centrecaps thinking the centrecaps for all Borbet A's were the same, however it seems that's not the case as the new flush caps i bought are about 2/3mm too wide in diameter and won't sit in the recess. After waiting a week for them to arrive and not fit, obviously I was a bit angry

Anyways, I've got a couple theories such as they are model/PCD/size specific, one of the parts I've bought is fake etc etc etc so does anyone have any information to shed on this?

Thanks in advance

[OrangeBlue]

Hi,

what size are your A-Types, what type of centrecaps do you have?

As i know the centrecaps are 16cm in diameter +/- a little.., they fit for 15",16",17" and 18".


I have all four types of centrecaps laying here, they all fit my 16x9 with 5x110 pcd.

I have to check if they fit my 16x9 with 4x100 pcd.

Greetz...

[Shieldsy94]

Hi,

what size are your A-Types, what type of centrecaps do you have?

As i know the centrecaps are 16cm in diameter +/- a little.., they fit for 15",16",17" and 18".


I have all four types of centrecaps laying here, they all fit my 16x9 with 5x110 pcd.

I have to check if they fit my 16x9 with 4x100 pcd.

Greetz...

Mine are 14s with a 6j width. May see the pattern here...

[OrangeBlue]

Mine are 14s with a 6j width.

I guess it's kinda hard to fid some caps for the 14s...

Maybe this is something for you...

Centre caps

or these...

Centre caps 2

Good luck...


Greetz

[a112]

Get them on a lathe, remove the excessive material and if the bolt securing hole doesn't fit get that filled and redrilled.

If you're lazy, I may have some 13" caps (hex nut type) available.

Cheers!

[Dipper]

Hey did someone say they have a few sets of these?