where to get the correct wheel spacers to run these wheels???

[1988montecarloss]

first off, i know, needs moar low, tires are too big, etc. but the centers of these wheels are too small to fit over the hubs of the bmw and they could use about an inch or so spacer to sit a little better on the car. so where could i get hub centric spacers so i could run them without the car shaking while its going down the road?.

wheels came off my 88 monte carlo ss so they are the same bolt pattern as the stock bmw wheels, once i get them mounted right ill put smaller tires on them, cut the springs, scrape everywhere etc.

[Jorge]

Adaptec sponsor!

[Ollie]

or bore out the hub

[1988montecarloss]

or bore out the hub

if i was to bore it out what would i have to get it bored to for the wheels to be hubcentric like the stock bmw wheels? and could any machine shop do it?

[MrZog]

if i was to bore it out what would i have to get it bored to for the wheels to be hubcentric like the stock bmw wheels? and could any machine shop do it?

BMW centerbore (except the E39) is 72mm . . any machineshop should be able to do that . .