Hamann/OZ PG1's, WTF PCD is this?

[gman1227]

if they are 5x120, give em to me , really look forward to seeing them put together great looking set

[Jesus Christ]

The CB is probably 74.1 like a e39 too

[jacbo]

This thread brings the lawls.

OP, just use the method suggested by Anonymoose. While the other one is technically correct, there's no need to do any calculations.

[czarlos]

As per my measurements, they should be 5x108, approximately 67mm center bore, looks like these came off some sort of Ferrari. Nice!

[Jesus Christ]

As per my measurements, they should be 5x108, approximately 67mm center bore, looks like these came off some sort of Ferrari. Nice!

so they wont bolt on to the e36? that sounds kinda strange but i have seen stranger things.

[czarlos]

so they wont bolt on to the e36? that sounds kinda strange but i have seen stranger things.

Nope, didn't even fit over the center bore. That was my initial red flag. Then I tried matching the bolt pattern to the spare on my Z, no dice. I even had a spare 5x112 rotor lying around and same deal.

Pretty logical to me considering they are 13in in width

Further evidence

[Jesus Christ]

well there it is, never seen that before

good find! try to bolt them on to a volvo haha

[czarlos]

well there it is, never seen that before

good find! try to bolt them on to a volvo haha

I want to haha, just gotta find one