So, I have a set of style 5's I am re-doing to run as a spare set of wheels.
Normally, EVERY time I have ever done a set of RSs I have had them powder coated. Well, these are cheap so I was going as cheap as possible.
So what do I do, go get some rattle cans. Well, with the tight mesh of the Style 5's it is IMPOSSIBLE to get paint into grooves without overspraying which then runs.
So, now I have a set of wheel faces that look like dick up close. I honestly dont really care too much as these dont mean a whole lot to me but that's not how I roll.
Anyone have some advise?
Normally, EVERY time I have ever done a set of RSs I have had them powder coated. Well, these are cheap so I was going as cheap as possible.
So what do I do, go get some rattle cans. Well, with the tight mesh of the Style 5's it is IMPOSSIBLE to get paint into grooves without overspraying which then runs.
So, now I have a set of wheel faces that look like dick up close. I honestly dont really care too much as these dont mean a whole lot to me but that's not how I roll.
Anyone have some advise?
Comment