Enkei replacement lips?

[320icar]

im looking for replacement lips for enkei sporsh wheels.

the setup is 17x8 et9 and 17x9 et9. the lip i need replacing is the front one. they look like this.

they are a 3 piece wheel. i live right near kodiak racing (which make wheels, lips etc) but aparently they only make lips for bbs rs and rm's. which doesn't help me. i've searched on a few sites, checked ebay, used google. went to enkei's website etc. and haven't found anything.

does anyone know where you can pick these up???? or i guess if i have to, a single full replacement wheel in the same specs.

[Pat]

Or, see if rotiform can do new lips for you!

[320icar]

so i guess no one knows eh?

yes i could go to somewhere like rotiform, but i'd rather not spend as much on one replacement lip as i did the entire set.

[jasonslackisrad]

call enkei.

[Jesus Christ]

rotiform or memoryfab will have them for sure

[clown_dog]

Hey bro, I have the same wheel lips and wanted some replacements also.

Except mine are Rawlings and they just use what I believe to be the enkei inner and outter barrel.

Any luck with your wheels?

These are mine for reference. 17x8 29 hole three piece et6 offset.

[Hart63]

It is possible, however Enkei doesn't make any more of these rims, and doesn't have any idea where to get them from since they haven't been made for 8 years . Your best bet is to call a wheel repair specialist.

[KyleAnderson]

In what way is the lip damaged? Replacement lips are going to be hard to find, so hopefully it's repairable.

[Jlyons617]

I'm suprised Someplace doesn't make blank lips that you could get machined with the right bolt spacing.

[clown_dog]

I'm suprised Someplace doesn't make blank lips that you could get machined with the right bolt spacing.

I know, I think this should definitely be a thing. So many different variances. would be cool to just order pre drilled.

In what way is the lip damaged? Replacement lips are going to be hard to find, so hopefully it's repairable.

Not sure if this was to me or not. But they aren't damaged, just wanting to widen them. I can get some made, but off the shelf from the manufacture where possible is always the best.