Wheel spacer help. Trying to get stanced, help a brother out?

[RL.]

I am trying to figure out how much of a spacer I need to get on my car. I know the front needs about 15-20, and the rear needs about 25-30mm. IAnyway, I tried to measure the horizontal wheel/fender gap with a metric ruler but didn't get accurate results.

Does anyone know of a method that's accurate? I just don't want to end up getting a 15mm spacer then needing a 20.

[Petis]

get the 20mm and adjust camber if needed. Better to be too big than too small..... In lots of lifes situations

[smshirk]

Having the right tool to measure would be good, but you might contact these folks at http://www.motorsport-tech.com/contact.html and they will walk you through how to do it. they make adapters/spacers to order. Even if you don['t buy them there they will help you out.


but if you want to be very accurate use a caliper ruler...see a picture here http://www.garrettspecialties.com/tr...er-p-3656.html

[kingston]

im also trying to do this since my car is a unusual build its hard to figure out what ill need