Post your custom wheels

[SIN3]

car sold:

AME Shallen MX with SBC finish (super brilliant chrome)

20x9.5 -18et *with spacer* (5 inch lip up front)

[SpinFin]

-----

Rear:


Front:


-----



-----



-----

[Brian Fantana]

N/P,
I'll try to get alot of pics when i pull them apart again and mount the face on the very bottom to get a bit more lip and add new bolts

[Tuck&Poke]

thanks, its those little tips that make it that much easier when you actually get down to it.

[Brian Fantana]

I used just the all weather sealant that you can find at Vatozone/HD/Wally World all that good stuff. As far as bathroom caulk i wouldnt know, but for the price of the sealant i'd just go with something thats made for it since it's not going to cost you a shit load.

Be prepare to buy about 6 tubes tho, i think thats about what i went through..atleast by the end of it all.
W. sandwhich faces i did a nice thick bead on the seam between the face and barrel (before i had the lip or bolts on) then added the lip, bolts. Torqued and used the cone cap from the sealant to smooth out the sealant i placed on the entire sandwhiched area. Just take your time but its nearly impossible to see if you missed a spot or not.

[Tuck&Poke]

Be prepared...it can happen. Dont just smoother it with sealant and take your time to ensure all areas are covered and you should be good.
I had stepped lips in the front so it didnt just seat flush on the barrel you had to get it up in this gap between the barrel and face (lip hung over it)

yea im gonna have the same problem with the fronts. Sandwiched faces are a bitch cause you gotta seal both inner and outer. Question, ive heard about people using bathroom caulking, any input on this?

[Brian Fantana]

i really hope that doesnt happen to me

Be prepared...it can happen. Dont just smoother it with sealant and take your time to ensure all areas are covered and you should be good.
I had stepped lips in the front so it didnt just seat flush on the barrel you had to get it up in this gap between the barrel and face (lip hung over it)

[Saukkii]

hello again, last weekend was 100+ motorshow in finland and my friend take very hot picture from my rear wheel:

http://sasu.kuvat.fi/kuvat/Tampere%20100%2026-27.9.2009/DSC_8455_2.jpg/full

[Saukkii]

Justin...finally some pics...looks bad-ass....didn't know you polished them yourself....i know that is alot of time consuming.....

so nice stance! rims looks good and car looks so clean!

[Tuck&Poke]

i really hope that doesnt happen to me

[Brian Fantana]

Justin...finally some pics...looks bad-ass....didn't know you polished them yourself....i know that is alot of time consuming.....

Yup, was a shit ton of work, especially the bolts...lol.
Took about 2 months of off and on work, and taking apart the fronts twice since they didnt seal completely the 1st time

[junjdm]

Kinesis Supercups, Fully polished
18x9 ET 45
18x10 ET 55
Polish job done by myself..

Justin...finally some pics...looks bad-ass....didn't know you polished them yourself....i know that is alot of time consuming.....

[bjh102]

Yea you can find it on no pokemon shit thread..



side/stance shit

sooo bad ass!!!!

[ECKS///M3]

The boy dun good!

[Brian Fantana]

Kinesis Supercups, Fully polished
18x9 ET 45
18x10 ET 55
Polish job done by myself..