-
www.Low-Familia.at -
www.Low-Familia.atComment
-
-
what up bud ... thank you, good to see you on here!www.Low-Familia.atComment
-
well look who it isComment
-
what up budwww.Low-Familia.atComment
-
just trying to get as low as you lol getting ready to redo my wheelsComment
-
sweet ... i just got started on my futures yesterday, finished removing all the bolts today.www.Low-Familia.atComment
-
-
haha, freakin awesome... i want one.!!www.Low-Familia.atComment
-
-
thank you sir
figure i'll throw this in ther so some of you who haven't looked at the built yet know what i am up to at the moment.
To get the faces off was really easy.
Took a rubber head hammer and a towel, placed the towel over the face just in case so i don't pit it. Kept hitting each spoke in circles till the face fell out. Cake work. This is the most important piece for me since it needs most of the work done to. Also noticed that one of the barrels is cracked which the seller did not mention to me. They were holding air but just as precaution i am either going to get this fixed or get a new barrel.
On to the pics.
As you can see the lips are still attached to the barrels, There are couple of ways to tackle this I could either use a heat gun and sit there for hours till the silicone lets up and separate the lips or find a nice hot owen.
In this case i'll take the 2nd option and take these to www.4everkustoms.com where they have an owen you can fit a donkey in. :biggrin: I'll post pics of that later. If you have an owen big enough to fit your wheels in your kitchen then that would be an option.
www.Low-Familia.atComment
-
looks freaking dope! that car on that shirt is my gf's car
check it out
she rolls on coils though
Last edited by vdubwardo; 05-30-2010, 02:38 PM.Comment
-
thanks,
her car looks really goodwww.Low-Familia.atComment
-
dude, you live minutes from me and I have never seen your mk5 lol wuddup wit dat?
-Dan
Comment
Tweet
Comment