If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Man, love your e34. Question though - you said resonator delete?
I have magnaflow cat to single 2.5" non res - magnaflow muffler on my obd1 s52 e30 - and am not too much of a fan of the sound - lil raspy... was thinking of putting a resonator on (I've never had one on since the swap) to see if it'll clean it up. What do you think???
Honestly, miss the sound of my UUC exhaust on the 95 m3 below- that was my fav sound...
Man, love your e34. Question though - you said resonator delete?
I have magnaflow cat to single 2.5" non res - magnaflow muffler on my obd1 s52 e30 - and am not too much of a fan of the sound - lil raspy... was thinking of putting a resonator on (I've never had one on since the swap) to see if it'll clean it up. What do you think???
Honestly, miss the sound of my UUC exhaust on the 95 m3 below- that was my fav sound...
A small resonator should help with the rasp imo, and it should be fairly cheap to mess around with.. I wanted to get an Eisenmann but I may just wait until I can go FI and redo the entire exhaust to a single tip.
I finally decided to put in the Ground Control spec E30 camber plates that have been sitting in my garage for the last 8 months.
I tried getting these on Monday and over torqued 2 of the mounting studs clean off.
Called GC and a has a set of replacement mounts sent, slapped them on last night and everything works fine so far. In case anybody is wondering they recommend no more than 18 foot pounds of torque on these.
Still rolling stock right now but my new set should be finished this month.
Comment