Tweet
i designed them. my welder isnt that strong so i had a local industrial welding place do the cutting and welding. would have taken me forever
-
Disclaimer:
I am rude, opinionated, and sometimes come off as a dick. I am just speaking my mind. If it offends you, PM me. Don't go whine to someone else. I am civil, talk to me, just dont be stupid.
and USE THE SEARCH BUTTON -
Thanks!
Any clearance problems with the hood raising the engine that much?
Comment
-
lulz at hood clearance anywhere...water inlet has to be reclocked, the distributor and carb stick up through the hood, had to cut out for em.
im gonna run this intake on it
Disclaimer:
I am rude, opinionated, and sometimes come off as a dick. I am just speaking my mind. If it offends you, PM me. Don't go whine to someone else. I am civil, talk to me, just dont be stupid.
and USE THE SEARCH BUTTONComment
-
Daaaaamn! That's gonna be nuts.
Thanks for the info. I'm about to raise the motor on my na. Just not sure how many inches I can go.Comment
-
i did an inch with ZERO problems witht he stock motor to get it above the subframeDisclaimer:
I am rude, opinionated, and sometimes come off as a dick. I am just speaking my mind. If it offends you, PM me. Don't go whine to someone else. I am civil, talk to me, just dont be stupid.
and USE THE SEARCH BUTTONComment
Comment